Thanks for all the help and the links too. Is this not a good route? The hood US — top , though modified, continued to have a removable frame that had to be erected before the cover was put on. A third car was constructed for John Milne of Scotland and all three cars survive. Re: Fender Flares 4. The original 'frogeye' Sprite had been introduced specifically to fill the gap in the market left by the end of production of the MG T-type Midget as its replacement, the MGA had been a significantly larger and more expensive car with greater performance.
MG Midget and Sprite Technical 1500 engine and tuning guide BBS discussion at MG-Cars.net
Return to the Photo Gallery Index Page. Your aim is a low speed engine, rpm max, with ft ib of torque, and will comfortably exceed HP, and pull seamlessly from and will not leak oil. If it is, the valve sizes and ports do not need looking at, but a small amount of material should be removed from the chamber wall where the inlet valve is masked. This car features Preform Resources' bodywork, both front and rear. I applaud that but have a in my midget. Project Gallery.
engine and tuning guide | MG Midget and Sprite Technical | OS-STROMY.INFO
Return to the Photo Gallery Index Page. I am not anti A series in fact I loved them back in the 70's and 80's but I don't have one now. Car Kendall Jones purchased and updated Peter's Midget. It allows understanding and insight to a piece of engineering that is in the minority in threads on this site yet has been installed to a lot of midgets. After a number of threads referring to engines and the odd reference to a lack of info on this site; I have at last found a reference I have read up in the past that has given me insight and help.
Project Gallery: Spridget (Sprite and Midget) Body Parts
Description: Use a 4 needle and heavy spring as a start probably 1 too rich. I am assuming that you have, or have access to the knowledge to put a standard engine together, as your new thing will not be much different to standard. MG Midget replacement fiberglass hood The hood comes with steel reinforcements and nut plates for the hinges bonded in. The in European spec came with compression, the US spec with 7.